2010 Chrysler Town & Country Owner Manual - Page 177
2010 Chrysler Town & Country Manual
Page 177 highlights
176 UNDERSTANDING THE FEATURES OF YOUR VEHICLE Deactivating Electronic Speed Control A soft tap on the brake pedal or pulling the Electronic Speed Control lever (CANCEL) toward you will deactivate the Electronic Speed Control without erasing the set speed memory. Pushing the ON/OFF button to the OFF position or turning OFF the ignition erases the set speed memory. RESUME ACCEL position, the set speed will continue to increase until the lever is released, then the new set speed will be established. Tapping the Electronic Speed Control lever to RESUME ACCEL once will result in a 1 mph (1.6 km/h) speed increase. Each time the lever is tapped speed increases, so tapping the lever three times will increase speed by 3 mph (4.8 km/h), etc. Resuming Speed To resume a previously set speed, raise the Electronic To decrease speed while Electronic Speed Control is set, Speed Control lever (RESUME ACCEL) upward, and push down and hold the Electronic Speed Control lever release. Resume can be used at any speed above 25 mph in SET DECEL. If the lever is continually held in the SET (40 km/h). DECEL position, the set speed will continue to decrease Varying The Speed Setting until the lever is released. Release the lever when the When the Electronic Speed Control is set, you can in- desired speed is reached, and a new set speed will be crease speed by pushing up and holding the RESUME established. ACCEL lever. If the lever is continually held in the Tapping the Electronic Speed Control lever to SET DECEL once will result in a 1 mph (1.6 km/h) speed decrease. Each time the lever is tapped, speed decreases.