2010 Chrysler Town & Country Owner Manual - Page 255

254 UNDERSTANDING YOUR INSTRUMENT PANEL Oil Change Required Your vehicle is equipped with an engine oil change indicator system. The Oil Change Required message will flash in the EVIC display for approximately 10 seconds, after a single chime has sounded, to indicate the next scheduled oil change interval. The engine oil change indicator system is duty-cycle based, which means the engine oil change interval may fluctuate dependent upon your personal driving style. 2. Fully depress the accelerator pedal, slowly, three times within 10 seconds. 3. Turn the ignition switch to the OFF/LOCK position. NOTE: If the indicator message illuminates when you start the engine, the oil change indicator system did not reset. If necessary, repeat these steps. Trip Functions Press and release the MENU button until one of the Unless reset, this message will continue to display each following Trip Functions displays in the EVIC. time you turn the ignition switch to the ON/RUN Press the STEP button to scroll through all the Trip position. To turn off the message temporarily, press and Computer functions. release the Menu button. To reset the oil change indicator system (after performing the scheduled maintenance) The Trip Functions mode displays the following information. perform the following steps. 1. Turn the ignition switch to the ON position (do not Average Fuel Economy Shows the average fuel economy since the last reset. start the engine). When the fuel economy is reset, the display will read