2010 Chrysler Town & Country Owner Manual - Page 482

MAINTAINING YOUR VEHICLE 481 NOTE: On vehicles equipped with High Intensity Discharge (HID) headlamps, when the headlamps are turned on, there is a blue hue to the lamps. This diminishes and becomes more white after approximately 10 seconds, as the system charges. Quad Headlamps 1. Raise the hood to access the high or low beam bulbs at the rear of the headlamp housing. CAUTION! Do not touch the new bulb with your fingers. Oil contamination will severely shorten bulb life. If the bulb comes in contact with an oily surface, clean the bulb with rubbing alcohol. 5. Reconnect the wiring connector to the bulb. Front Park/Turn Signal Lamp 2. Release the two tabs on the side of the connector and 1. Raise the hood to access the rear of the headlamp remove the connector from the bulb. housing. 3. Twist the headlamp bulb and pull the bulb from the 2. Twist the turn signal socket and remove from the headlamp housing. headlamp housing, then pull the bulb out. 4. Install the new headlamp bulb and twist until locked 3. Push the new bulb into the socket and reinstall the into the headlamp housing. socket by twisting until locked into the headlamp housing. 7