2010 Chrysler Town & Country Owner Manual - Page 198
2010 Chrysler Town & Country Manual
Page 198 highlights
UNDERSTANDING THE FEATURES OF YOUR VEHICLE 197 successfully accepted the frequency signal. The indica- Troubleshooting Tips tor light will flash slowly and then rapidly when fully If you are having trouble programming HomeLink, here are some of the most common solutions: trained. If you unplugged the device for training, plug it back in • Replace the battery in the original transmitter. at this time. • Press the LEARN button on the Garage Door Opener to complete the training for a Rolling Code. Then proceed with Step 4 under "Programming HomeLink," earlier in this section. • Did you unplug the device for training, and remember to plug it back in? Security It is advised to erase all channels before you sell or turn If you have any problems, or require assistance, please in your vehicle. call toll-free 1-800-355-3515 or, on the Internet at To do this, press and hold the two outside buttons for www.HomeLink.com for information or assistance. 20 seconds until the red indicator flashes. Note that all General Information channels will be erased. Individual channels cannot be This device complies with FCC rules Part 15 and Industry erased. Canada RSS-210. Operation is subject to the following The HomeLink Universal Transceiver is disabled when two conditions: the Vehicle Security Alarm is active. 1. This device may not cause harmful interference. 3