2010 Nissan Rogue Owner's Manual - Page 170

Audio main operation Head unit: The radio has an FM diversity reception system, which employs two antennas printed on the rear window. This system automatically switches to the antenna which is receiving less interference. The auto loudness circuit enhances the low and high frequency ranges automatically in both radio reception and CD playback. ON·OFF/Volume control: Turn the ignition switch to the ACC or ON position, and then push the ON·OFF/VOLUME control knob while the system is off to call up the mode (radio, CD or AUX) which was playing immediately before the system was turned off. While the system is on, pushing the ON·OFF/ VOLUME control knob turns the system off. Turn the ON·OFF/VOLUME control knob to adjust the volume. AUDIO button: Push the AUDIO button to change the selecting mode as follows. BASS ? TREBLE ? FADER ? BALANCE ? SSV ? BEEP ? off , ) or SEEK ( , Push the TUNE ( ) button to adjust Bass and Treble to the desired level. Use the TUNE or SEEK button also to adjust Fader or Balance modes. Fader adjusts the sound level between the front and rear speakers and Balance adjusts the sound between the right and left speakers. To turn the beep sound off or on, push the TUNE button until the desired mode is displayed. This turns on or off the beep sound when audio buttons are pushed. To change the Speed Sensitive Volume (SSV) mode to OFF, LOW, MID or HIGH, push the TUNE button until the desired mode is displayed. Once you have adjusted the sound quality to the desired level, push the AUDIO button repeatedly until the radio or CD display reappears. Otherwise, the radio or CD display will automatically reappear after about 10 seconds. CLOCK button: Push the CLOCK button to turn on or off the CLOCK display. See "CLOCK" in the "2. Instruments and controls" section for the detailed clock adjustment operation. DISPLAY CHANGE: This button will work during FM or satellite radio (if so equipped) and CD operation. Find the detailed function in the description of each item. Radio operation RADIO (FM/AM/SAT) band select: Pushing the RADIO button will change the band as follows: (Without satellite radio) AM ? FM ? AM (With satellite radio) AM ? FM ? SAT (XM) ? AM When the RADIO button is pushed while the ignition switch is in the ACC or ON position, the radio will come on at the station last played. The last station played will also come on when the ON·OFF/VOL control knob is pushed to ON. The satellite radio mode will be skipped unless an optional satellite receiver and antenna are installed and an XM® satellite radio service subscription is active. Satellite radio is not available in Alaska, Hawaii and Guam. If another audio source is playing when the RADIO button is pushed, the compact disc will 4-18 Heater, air conditioner, audio and phone systems