2010 Nissan Rogue Owner's Manual - Page 301
2010 Nissan Rogue Manual
Page 301 highlights
INSTALLING FRONT LICENSE PLATE ¯ EXCEPT FOR Krom MODELS Use the following steps to mount the license plate: Before mounting the license plate, confirm that the following parts are enclosed in the plastic bag...License plate bracket J-nut 6 2 Screw 6 2 Screw grommet 6 2 1. Temporarily place the license plate bracket A by aligning the lower part * of it with the B lines * on the bumper. 2. Mark the pilot hole points with a felt-tip pen through the holes of the license plate bracket. 3. Remove the license plate bracket. 4. Carefully drill two pilot holes using a 0.39 in (10 mm) drill bit at the marked locations. (Be sure that the drill only goes through the fascia, or damage to the nut may occur.) 5. Insert grommets into the hole on the fascia. STI0599 Technical and consumer information 9-11