2010 Nissan Rogue Owner's Manual - Page 187
2010 Nissan Rogue Manual
Page 187 highlights
If the memo pad is full, the system asks if you wish to record over the oldest memo. "Delete" C * to enter the code "1234". The code is always "1234" regardless of the number of phones paired. NOTE: The pairing procedure must be performed when the vehicle is stationary. If the vehicle starts moving during the procedure, the procedure will be cancelled. Also, see "Pairing procedure" earlier in this section for additional information. Up to 5 phones can be paired. If you try to pair a sixth phone, the system announces that you must first delete one phone or replace an existing phone. If you try to pair a phone that has already been paired to your vehicle's system, the system announces the name the phone is already using. The pairing procedure will then be canceled. When prompted by the system, choose from the following commands: . . "New phone" - see "Pairing procedure" earlier in this section. "Replace phone" - The system announces the names of the phones already paired and asks which you would like to replace. Once you say the name of the phone you wish to replace, the paring procedure will begin. (See "Pairing procedure" earlier in this section.) . "List phone" - See the description below. B * "List Phones" The Delete command erases all memos. The system asks you to confirm this action before deleting all memos. Setup Use the List Phones command to hear the names of the phones currently paired. If no phones are paired, the system announces, "No paired phones to list." The system then ends the VR session. "Select Phone" C * Use the Select Phone command to select a phone of lesser priority when two or more phones paired with Bluetooth® Hands-Free Phone System are in the vehicle at the same time. The system asks you to name the phone and confirm the selection. Once the selection is confirmed, the selected phone remains active until the ignition switch is turned OFF or you select a new phone. "Change Priority" D * Use the Setup command to change options associated with the Bluetooth® Hands-Free Phone System. "Pair Phone" A * Use the Change Priority command to change the priority level of the active phone. The priority level determines which phone is active when more than one paired Bluetooth® phone is in the vehicle. The system states the priority level of the active Use the Pair Phone command to pair a phone to the Bluetooth® Hands-Free Phone System. When you are asked to enter a PIN code for pairing your Bluetooth® cellular phone, operate it Heater, air conditioner, audio and phone systems 4-35