2010 Nissan Rogue Owner's Manual - Page 171
2010 Nissan Rogue Manual
Page 171 highlights
automatically be turned off and the last radio station played will turn on. The FM stereo indicator ST will glow during FM stereo reception. When the stereo broadcast signal is weak, the radio will automatically change from stereo to monaural reception. TUNE (Tuning): or for manual Push the TUNE button tuning. To move quickly through the channels, push and hold the TUNE button. SEEK tuning: . For AM and FM radio or to tune Push the SEEK button from low to high or high to low frequencies and to stop at the next broadcasting station. . For satellite radio Push the SEEK button or to tune to the first station of the next or previous category. SCAN tuning: Push the SCAN button to tune from low to high frequencies and stops at each broadcasting station for 5 seconds. Pushing the button again during this 5 seconds period will stop SCAN tuning and the radio will remain tuned to that station. If the SCAN tuning button is not pushed within 5 seconds, SCAN tuning moves to the next station. PRESET select: Push the PRESET A·B·C button to go to the next PRESET. After choosing from the PRESET A, B or C, you can select the desired station by to . pushing the station preset buttons to Station memory operations: 5. Other buttons can be set in the same manner. If the battery cable is disconnected, or if the fuse opens, the radio memory will be erased. In that case, reset the desired stations. Radio Data System (RDS): RDS stands for Radio Data System, and is a data information service transmitted by some radio stations on the FM band (not AM band) encoded within a regular radio broadcast. Currently, most RDS stations are in large cities, but many stations are now considering broadcasting RDS data. RDS can display: ...Station call sign, such as "WHFR 98.3". Station name, such as "The Groove". Music or programming type such as "Classical", "Country" or "Rock". Traffic reports about delays or construction. 18 stations can be set for PRESET A, B and C. The PRESET A, B and C function allows you to store a combination of FM, AM and SAT (if so equipped) stations for easy access. 1. Push the PRESET A·B·C button to change between storage banks. 2. Tune to the desired station using the SEEK, SCAN or TUNE button. 3. Push and hold any of the desired station preset buttons (1-6) until a beep sound is heard. (The radio mutes when the select button is pushed.) 4. The station indicator will then come on and the sound will resume. Memorizing is now complete. If the station broadcasts RDS information, the RDS icon is displayed. RADIO DISPLAY CHANGE: When the DISP button is pushed for less than 1.5 seconds during FM or SAT (if so equipped) radio mode, the radio display will change in the Heater, air conditioner, audio and phone systems 4-19