2010 Nissan Rogue Owner's Manual - Page 303
2010 Nissan Rogue Manual
Page 303 highlights
VEHICLE LOADING INFORMATION ¯ FOR Krom MODELS Use the following steps to mount the license plate: Before mounting the license plate, confirm that the following parts are enclosed in the vinyl bag...License plate bracket J-nut 6 2 Screw 6 2 Screw grommet 6 2 . 8. Insert a J-nut into the license plate bracket before placing the license plate bracket on the fascia. 9. Install the license plate bracket with the screws. 10. Install the license plate with bolts that are not longer than 0.55 in (14 mm). . WARNING . 1. Park the vehicle on flat, level ground. 2. Temporarily place the license plate bracket A while aligning points * of the front bumper B fascia with holes * in the license plate bracket. A B 3. Confirm that points * and * are aligned. It is extremely dangerous to ride in a cargo area inside the vehicle. In a collision, people riding in these areas are more likely to be seriously injured or killed. Do not allow people to ride in any area of your vehicle that is not equipped with seats and seat belts. Be sure everyone in your vehicle is in a seat and using a seat belt properly. TERMS It is important to familiarize yourself with the following terms before loading your vehicle: . 4. Remove the license plate bracket. A 5. Carefully drill two shallow pilot holes * using a 0.39 in (10 mm) drill bit at the marked locations. (Be sure that the drill only goes through the fascia, or damage to the nut may occur.) 6. Insert grommets into the hole on the fascia. 7. Insert a flat-blade screwdriver into the grommet hole to add a 908 turn onto the C part * . . Curb Weight (actual weight of your vehicle) - vehicle weight including: standard and optional equipment, fluids, emergency tools, and spare tire assembly. This weight does not include passengers and cargo. GVW (Gross Vehicle Weight) - curb weight plus the combined weight of passengers and cargo. Technical and consumer information 9-13