Brother International AIRFLOW 3000 Operation Manual - Page 21

English 4. Lower the needle threader lever 6 on the left side of the machine as much as possible.  The thread passes through the eye of the needle. 5. Release the needle threader lever 6. 6. Carefully pull the loop of the thread through the eye of the needle to pull out the end of the thread. c) Guide the thread down the channel and across through the threading points 5 6 7 next to the green color marks following the numerical order in the accompanying illustration.      %!      7. Raise the presser foot lifting lever 1, then pass the end of the thread through the presser foot, and then pull out about 5 cm (2 inches) of thread toward the rear of the machine. 5 cm Threading the right needle 1. Slide the needle threader chenge switch to the "R" mark on the machine. Two needles One needle NOTE: Make sure the thread is through the right of the separater . You can use the needle threader in the same way as for the left needle. (See "Using the needle threader") NOTE: For details on these operations, watch the video. $! 2. Run the thread in the sequence illustrated, following the green color and the number next to each threading point. a) Pull the thread off the spool and directly up through the thread holder 1 and the thread holder 2 on the thread tree from back to front. b) Hold the thread with your left and right hands, then pass the thread through the thread guide 3, and then pass the thread through the tension disc 4 which is in the channel next to the green thread tension dial. https://s.brother/cvtkb/ 19