Brother International LK3-B432E MKII Instruction Manual - English - Page 24

4 . LUBRICATION 4. LUBRICATION CAUTION Turn off the power switch before starting lubricating, otherwise the machine may operate if the foot switch is depressed by mistake, which could result in injury. Be sure to wear protective goggles and gloves when handling the lubricating oil and grease, so that they do not get into your eyes or onto your skin, otherwise inflammation can result. Furthermore, do not drink the oil or eat the grease under any circumstances, as they can cause vomiting and diarrhoea. Keep the oil out of the reach of children. NOTE 1: Fill the machine with oil when the oil level is down to about one-third full in the oil sight glass. If oil is not added and the oil drops below this level, there is the danger that the machine may seize during operation. NOTE 2: Be sure to let the machine operate for a while after adding the oil. NOTE 3: If there is no more oil on the felt of the shuttle race base, problems with sewing may result, so add oil to the felt until it is slightly soaked. NOTE 4: Use only specified Brother oil (Nisseki Sewing Libe 10) for the machine oil. 4-1 . Lubrication points [LK3-B432E Mark II] LK3-B430E Mark II LK3-B431E Mark II LK3-B433E Mark II 1. Fill the arm-side oil tank with oil. * When setting up the sewing machine and when it hasn't been used for an extended period of time, be sure to add 2-3 drops of oil at the place indicated by the arrow. 2. Fill the bed-side oil tamk with oil q w 3. Add oil to the felt q of the shuttle race base. * When setting up the sewing machine and when it hasn't been used for an extended period of time, be sure to add 2-3 drops oil to the felt. 4. If using the liquid cooling tank w, fill it with silicon oil (100 mm2/s). LK3-B430E-, B431E-, B432E-, B433E- Mark II 18