Brother International LK3-B432E MKII Instruction Manual - English - Page 43
-9.Work clamp pressure adjustment(B432E Mark II), as much as pos
View all Brother International LK3-B432E MKII manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 43 highlights
10 . STANDARD ADJUSTMENTS [B432E Mark II] The maximum work clamp lift amount is 17 mm from the top of the needle plate when the machine is stopped. The lift amount is adjusted 13+10 mm at the time of shipment. y t 17mm w e r q While the machine is stopped, loosen the bolt q and move the presser roller attachment plate w vertically to adjust the lift amount. * When making this adjustment, check to see if the work clamp will open. Also, readjust the closing distance of the work clamp according to the second procedure of "10-10. Work clamp closing-distance adjustment". * Loosen the nut t and turn the stop lever adjusting screw y to adjust the position of the stop lever e so that it does not touch the adjusting ring r when the presser foot is raised. * If the work clamp cannot be raised or lowered, error code "E-61" or "E-63" will be displayed. 10-9.Work clamp pressure adjustment(B432E Mark II) Loosen the lower adjusting ring q as much as possible (to the extent that the material being sewn does not slip and alter the pattern). Then, adjust the pressure by turning the upper adjusting ring w. w q * Removal of the work clamp spring Lower the work clamp, then place the adjusting ring r e in the hole of the frame, remove the tip of the t adjusting screw from the lever holder r, and remove the work clamp spring t. e 37 LK3-B430E-, B431E-, B432E-, B433E- Mark II