Brother International MD-817 Service Manual - Page 40
Checking, Machine, Solenoids
View all Brother International MD-817 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 40 highlights
CHECKING THE MACHINE SOLENOIDS M Solenoid load of the machine Connector from the machine head Reverse switch 9 ® GND ® 8 5 0 Reverse solenoid Thread wiper solenoid Thread trimming solenoid (B737) Presser foot lift connecter Solenoid = GND 4 6 Presser foot lift switch 1. Remove the load connector (12P connector) of the machine from the connector part of the control box. 2. Measure with the tester set in the resistance range x 1 as follows. • The thread trimming solenoid at pins 4 and 5 is normal if the tester reads approx. 7ohms. • The thread wiper solenoid at pins 7 and 8 is normal if the tester reads approx. 5ohms. • ' The actuator at pins 9 and 12 is normal if the tester reads Oohms when pressed, and 000hms when released. • The presser lift solenoid at pins 1 and 4 is normal if the tester reads approx. 5ohms. • The presser lift switch at pins 2 and 5 is normal if the tester reads Oohms when pressed, and 000hms when released. - 36 -