Brother International PC-3000 Users Manual - English - Page 20
Thread take-up lever, Wire loop, Needle threader lever, Guide Large hook, Second set of hooks, Third
View all Brother International PC-3000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 20 highlights
2 1 1 2 5 1 5 1 2 5 11 2 4. While holding the end of the thread with your left hand, pass the thread through the guides in the order shown by the numbers. Note - If the thread is pushed down at 1 to make it taut, it can be passed around the other thread guides more easily. - Incorrectly feeding the thread will result in faulty sewing. Threading the take-up lever 4 1 1 Thread take-up lever 5. Lower the presser foot. 6. Guide the thread through the wire loop and thread through needle eye. 1 Wire loop * You do not need to pull the bobbin thread up before you start sewing. 7. Pass the thread underneath the presser foot and pull it out from the rear of the machine by about 5 cm. Note Always raise the presser foot before removing the upper thread from the machine or damage may occur to the auto thread tension unit. 8. When using the auto-threading device, gently pull the thread towards you. 1 Needle threader lever 2 Guide (Large hook) * Lowering the presser foot will engage the automatic tension and will allow you to grip the thread as you proceed. 9. Lower the needle threader lever all the way down using your left index finger. Check that the thread is held by the guide (large hook) and that the third hook on the needle threader has passed through the eye of the needle. 1 Second set of hooks 2 Third hook 10. As you lower the needle threader lever, pull the thread to the left and catch it on the large hook. When the needle threader lever is in the lowest position, pull the thread in front of the needle's eye and catch it on the third hook. 17