Brother International PC-3000 Users Manual - English - Page 27
Presser Foot
View all Brother International PC-3000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 27 highlights
PRESSER FOOT Changing the presser foot 1. Press the "NEEDLE POSITION" button to raise the needle, and then turn off the power. 2. Raise the presser foot lever. 3. Press the black button located at the back of the presser foot holder to release the foot. 1 1 Presser foot holder 4. Place the presser foot pin directly below the holder-end and lower the presser foot lever to attach the presser foot. 1 Holder-end 2 Foot pin 1 2 Removing the presser foot holder (while cleaning, etc.) 5 6 1 Loosen the presser foot holder screw, then pull the presser foot holder down to remove it. Note When reattaching the presser foot holder, first attach the presser foot to the presser foot holder. Then, lower the presser foot lever, install the presser foot holder and securely tighten the presser foot holder screw. The thread tension may be inaccurate if the presser foot holder is incorrectly attached. 1 Disc-shaped screwdriver 24