Canon MultiPASS C755 Service Manual - Page 35
Disassembly 2, Disassembly 2., Scanning assembly
View all Canon MultiPASS C755 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 35 highlights
MultiPASS C755 Chapter 2: Assembly and Disassembly Disassembly 2. Scanning assembly (1) Perform disassembly 1. (2) Remove the three cables (e), connected to the SCNT board at the left side of the main unit. Also, remove the cables (f), connecting the SCNT board and the PCNT board. Then, remove the two cables (j), from the carriage motor and the ink sensor, and remove the cable guide (c). When you remove the cable guide, prise loose the tabs (d). (3) Remove the two screws (g). (4) Remove the two screws (a), and then take off the ground plate (b). (5) Remove the stopper (h), and then remove the control panel and ADF upper assembly. (6) Remove the two screws (i), and remove the ADF lower assembly. e g D e B 1 C h g Ai a e a b A B d E j D c C f E Figure 2-6 Disassembly 2 2-8