Cisco 3725 Software Configuration Guide - Page 122

Configuring 1-Port G.SHDSL WAN Interface Card Chapter 3 Configuring with the Command-Line Interface Command Purpose Step 14 Router# show interface atm 1/0 Verifies the ATM interface configuration. Step 15 Router# clear interface atm 1/0 Permits the configuration changes to take effect. Configuring ILMI on the DSLAM Connected to the ADSL WAN The ILMI protocol allows DSLAMs to be used for ATM address registration across an ATM User-Network Interface (UNI). If ILMI is configured on the G.SHDSL WIC, the ATM PVC must be configured on the DSLAM. All switch terminating connections use interface 0/0 to connect to the switch CPU. For information about configuring the DSLAM, see the Configuration Guide for Cisco DSLAMs with NI-2. Verifying ATM Configuration Use the following commands to verify your configuration: • To verify current configuration and to view the status for all controllers, use the show running-config command. • To view ATM controller statistics, use the show controllers atm slot/port command. • To verify the PVC status, use the show atm vc command. Make sure that active PVCs are up. • To help identify ATM related events as they are generated, use the debug atm events command. • To indicate which interfaces are having trouble, use the debug atm errors command. • To identify an entry for the ATM interface you configured and to show an entry for the ATM slot/port you configured, use the show ip route command. • To view the status of an ATM interface, use the show interface atm command. Make sure that the ATM slot/port and the line protocol are up, as shown in the following examples: Router# show interface atm 1/0 ATM1/0 is up, line protocol is up Hardware is DSLSAR (with Globespan G.SHDSL Module) MTU 4470 bytes, sub MTU 4470, BW 800 Kbit, DLY 2560 usec, reliability 255/255, txload 1/255, rxload 1/255 Encapsulation ATM, loopback not set Keepalive not supported Encapsulation(s):AAL5 AAL2, PVC mode 24 maximum active VCs, 256 VCs per VP, 2 current VCCs VC idle disconnect time:300 seconds Last input never, output 00:00:01, output hang never Last clearing of "show interface" counters 03:16:00 Queueing strategy:fifo Output queue 0/40, 0 drops; input queue 0/75, 0 drops 30 second input rate 0 bits/sec, 0 packets/sec 30 second output rate 0 bits/sec, 0 packets/sec 2527 packets input, 57116 bytes, 0 no buffer Received 0 broadcasts, 0 runts, 0 giants, 0 throttles 0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored, 0 abort 10798 packets output, 892801 bytes, 0 underruns 0 output errors, 0 collisions, 0 interface resets 0 output buffer failures, 0 output buffers swapped out Router# show atm vc VCD / Peak Avg/Min Burst 3-62 Software Configuration Guide for Cisco 2600 Series, Cisco 3600 Series, and Cisco 3700 Series Routers OL-1957-04