Cisco 3725 Software Configuration Guide - Page 92

Configuring 1-Port ADSL WAN Interface Card Chapter 3 Configuring with the Command-Line Interface Step 8 Step 9 Command Router(config-if-vc)# exit Router(config-if)# dsl operating-mode {ansi-dmt | auto | itu-dmt | splitterless} Purpose Exit from interface-atm-vc configuration mode. Configure the ADSL interface to operate in a specified mode: • ansi-dmt-ANSI full rate mode per T1.413 (ITU G.DMT Issue 1) • auto-Automatic detection mode • itu-dmt-ITU full rate mode (ITU G.DMT Issue 1) • splitterless-G.lite mode per ITU G.992.2 Step 10 Step 11 Step 12 Step 13 Router(config-if)# no shutdown Router(config-if)# exit Router(config)# exit Router# show interface atm 1/0 Caution This command is for testing or lab environments only. Using a configuration other than the default configuration for the DSL operating mode can lead to unpredictable behavior on the ADSL line. Activate the ATM interface. Exit from ATM interface configuration mode. Exit from global configuration mode. Verify the ATM interface configuration. Verifying ATM Configuration Use the following commands to verify configuration: • To verify current configuration and to view the status for all controllers, use the show running-config command. • To view ATM controller statistics, use the show controllers atm slot/port command. • To verify the PVC status, use the show atm vc command. Make sure that active PVCs are up. • To help identify ATM-related events as they are generated, use the debug atm events command. • To indicate what interfaces are having trouble, use the debug atm errors command. • To identify an entry for the ATM interface you configured and to show an entry for the ATM slot/port you configured, use the show ip route command. • To display the configured list of ATM static maps to remote hosts on an ATM network, use the show atm map command. • To view the status of ATM interface, use the show interface atm slot/port command. Make sure that ATM slot/port and line protocol is up, as shown in the following example: Router# show interface atm1/0 ATM 1/0 is up, line protocol is up Hardware is DSLSAR (with Alcatel ADSL Module) MTU 4470 bytes, sub MTU 4470, BW 800 Kbit, DLY 2560 usec, reliability 255/255, txload 1/255, rxload 1/255 Encapsulation ATM, loopback not set Keepalive not supported 3-32 Software Configuration Guide for Cisco 2600 Series, Cisco 3600 Series, and Cisco 3700 Series Routers OL-1957-04