Cisco 3725 Software Configuration Guide - Page 93

Configuration Examples

Get Cisco 3725 - PRI Dial Bundle Router PDF manuals and user guides
UPC - 746320810911
View all Cisco 3725 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 93 highlights

Chapter 3 Configuring with the Command-Line Interface Configuring 1-Port ADSL WAN Interface Card Encapsulation(s):AAL5 AAL2, PVC mode 24 maximum active VCs, 256 VCs per VP, 2 current VCCs VC idle disconnect time:300 seconds Last input never, output 00:00:01, output hang never Last clearing of "show interface" counters 03:16:00 Queueing strategy:fifo Output queue 0/40, 0 drops; input queue 0/75, 0 drops 30 second input rate 0 bits/sec, 0 packets/sec 30 second output rate 0 bits/sec, 0 packets/sec 2527 packets input, 57116 bytes, 0 no buffer Received 0 broadcasts, 0 runts, 0 giants, 0 throttles 0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored, 0 abort 10798 packets output, 892801 bytes, 0 underruns 0 output errors, 0 collisions, 0 interface resets 0 output buffer failures, 0 output buffers swapped out Router# show atm vc VCD / Interface 1/0.3 1/0.2 Name 2 1 Peak Avg/Min Burst VPI VCI Type Encaps SC Kbps Kbps Cells Sts 9 36 PVC MUX UBR 800 UP 9 37 PVC SNAP UBR 800 UP Router# show controllers atm 1/0 Interface ATM1/0 is up Hardware is DSLSAR (with Alcatel ADSL Module) IDB: 62586758 Instance:6258E054 reg_dslsar:3C810000 wic_regs:3C810080 PHY Inst:62588490 Ser0Inst:62573074 Ser1Inst: 6257CBD8 us_bwidth:800 Slot: 1 Unit: 1 Subunit: 0 pkt Size:4496 VCperVP:256 max_vp: 256 max_vc: 65536 total vc:2 rct_size:65536 vpivcibit:16 connTblVCI:8 vpi_bits:8 vpvc_sel:3 enabled: 0 throttled:0 WIC Register FPGA Dev ID (LB) FPGA Dev ID (UB) FPGA Revision WIC Config Reg WIC Config Reg2 Int 0 Enable Reg Value Notes 0x44 'D' 0x53 'S' 0x99 0x45 WIC / VIC select = WIC; CTRLE addr bit 8 = 1; OK LED on; LOOPBACK LED off; CD LED on; 0x07 Gen bus error on bad ADSL access 0x03 ADSL normal interrupt enabled ADSL error interrupt enabled Configuration Examples Examples of the following configurations are described in Appendix A, "Configuration Examples,"on page A-1: • VoATM over AAL2 on the ATM Interface Configuration Example, page A-12 • VoATM over AAL5 on the ATM Interface Configuration Example, page A-14 OL-1957-04 Software Configuration Guide for Cisco 2600 Series, Cisco 3600 Series, and Cisco 3700 Series Routers 3-33

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
  • 68
  • 69
  • 70
  • 71
  • 72
  • 73
  • 74
  • 75
  • 76
  • 77
  • 78
  • 79
  • 80
  • 81
  • 82
  • 83
  • 84
  • 85
  • 86
  • 87
  • 88
  • 89
  • 90
  • 91
  • 92
  • 93
  • 94
  • 95
  • 96
  • 97
  • 98
  • 99
  • 100
  • 101
  • 102
  • 103
  • 104
  • 105
  • 106
  • 107
  • 108
  • 109
  • 110
  • 111
  • 112
  • 113
  • 114
  • 115
  • 116
  • 117
  • 118
  • 119
  • 120
  • 121
  • 122
  • 123
  • 124
  • 125
  • 126
  • 127
  • 128
  • 129
  • 130
  • 131
  • 132
  • 133
  • 134
  • 135
  • 136
  • 137
  • 138
  • 139
  • 140
  • 141
  • 142
  • 143
  • 144
  • 145
  • 146
  • 147
  • 148
  • 149
  • 150
  • 151
  • 152
  • 153
  • 154
  • 155
  • 156
  • 157
  • 158
  • 159
  • 160
  • 161
  • 162
  • 163
  • 164
  • 165
  • 166
  • 167
  • 168
  • 169
  • 170
  • 171
  • 172
  • 173
  • 174
  • 175
  • 176
  • 177
  • 178
  • 179
  • 180
  • 181
  • 182
  • 183
  • 184
  • 185
  • 186
  • 187
  • 188
  • 189
  • 190
  • 191
  • 192
  • 193
  • 194
  • 195
  • 196
3-33
Software Configuration Guide for Cisco 2600 Series, Cisco 3600 Series, and Cisco 3700 Series Routers
OL-1957-04
Chapter 3
Configuring with the Command-Line Interface
Configuring 1-Port ADSL WAN Interface Card
Encapsulation(s):AAL5 AAL2, PVC mode
24 maximum active VCs, 256 VCs per VP, 2 current VCCs
VC idle disconnect time:300 seconds
Last input never, output 00:00:01, output hang never
Last clearing of "show interface" counters 03:16:00
Queueing strategy:fifo
Output queue 0/40, 0 drops; input queue 0/75, 0 drops
30 second input rate 0 bits/sec, 0 packets/sec
30 second output rate 0 bits/sec, 0 packets/sec
2527 packets input, 57116 bytes, 0 no buffer
Received 0 broadcasts, 0 runts, 0 giants, 0 throttles
0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored, 0 abort
10798 packets output, 892801 bytes, 0 underruns
0 output errors, 0 collisions, 0 interface resets
0 output buffer failures, 0 output buffers swapped out
Router#
show atm vc
VCD /
Peak
Avg/Min Burst
Interface
Name
VPI
VCI
Type
Encaps
SC
Kbps
Kbps
Cells
Sts
1/0.3
2
9
36
PVC
MUX
UBR
800
UP
1/0.2
1
9
37
PVC
SNAP
UBR
800
UP
Router#
show controllers atm 1/0
Interface ATM1/0 is up
Hardware is DSLSAR (with Alcatel ADSL Module)
IDB:
62586758
Instance:6258E054
reg_dslsar:3C810000
wic_regs:3C810080
PHY Inst:62588490
Ser0Inst:62573074
Ser1Inst: 6257CBD8
us_bwidth:800
Slot:
1
Unit:
1
Subunit:
0
pkt Size:4496
VCperVP:256
max_vp:
256
max_vc:
65536
total vc:2
rct_size:65536
vpivcibit:16
connTblVCI:8
vpi_bits:8
vpvc_sel:3
enabled: 0
throttled:0
WIC
Register
Value
Notes
---------------
---------- ----------
FPGA Dev ID (LB)
0x44
'D'
FPGA Dev ID (UB)
0x53
'S'
FPGA Revision
0x99
WIC Config Reg
0x45
WIC / VIC select = WIC;
CTRLE addr bit 8 = 1;
OK LED on;
LOOPBACK LED off;
CD LED on;
WIC Config Reg2
0x07
Gen bus error on bad ADSL access
Int 0 Enable Reg
0x03
ADSL normal interrupt enabled
ADSL error interrupt enabled
Configuration Examples
Examples of the following configurations are described in
Appendix A, “Configuration Examples,”
on
page A-1:
•
VoATM over AAL2 on the ATM Interface Configuration Example, page A-12
•
VoATM over AAL5 on the ATM Interface Configuration Example, page A-14