Cisco 3725 Software Configuration Guide - Page 136
Configuring Direct-Inward Dialing on a BRI Port - voip setup
UPC - 746320810911
View all Cisco 3725 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 136 highlights
Chapter 4 Configuring Voice-over-IP interface serial 0/0 clock rate 2000000 ip address 172.16.1.123 no shutdown Router SLC Configuration ! Configure pots dial-peer 1 dial-peer voice 1 pots destination-pattern +9........... port 1/0/0 ! Configure voip dial-peer 2 dial-peer voice 2 voip destination-pattern +14085274000 session target ipv4:172.16.1.123 ! Configure the voice port voice port 1/0/0 connection plar 14085274000 ! Configure the serial interface interface serial 0/0 ip address 172.16.65.182 no shutdown Configuring Direct-Inward Dialing on a BRI Port The following example shows how to configure a BRI port for direct-inward dialing (DID). This configuration allows the called number information from the ISDN Q.931 setup message to be used for routing on an ISDN line. In this example, a call comes in to router 1 on the BRI port. The DID information allows the router to route the call based on the called number. If the called number is 2xxx, the call is routed to router 2000, and if the called number is 3xxx, the call is routed to router 3000. Figure 4-5 illustrates the topology of this connection example. Figure 4-5 Configuring DID on a BRI Port 4-10 Software Configuration Guide for Cisco 2600 Series, Cisco 3600 Series, and Cisco 3700 Series Routers OL-1957-04