Dell C1048P Port Extender Networking Configuration Guide for the C9000 Series - Page 1155

Table 91. Creating a Non-Default VRF Instance Task Command Syntax Create a non-default VRF instance by specifying a name and VRF ID number, and enter VRF configuration mode. ip vrf vrf-name vrf-id VRF ID range: 1 to 512 and 0 (default VRF) Command Mode CONFIGURATION Assigning an Interface to a VRF You must enter the ip vrf forwarding command before you configure the IP address or any other setting on an interface. NOTE: You can configure an IP address or subnet on a physical or VLAN interface that overlaps the same IP address or subnet configured on another interface only if the interfaces are assigned to different VRFs. If two interfaces are assigned to the same VRF, you cannot configure overlapping IP subnets or the same IP address on them. Table 92. Assigning an Interface to a VRF Task Command Syntax Command Mode Assign an interface to a VRF instance. ip vrf forwarding vrf-name INTERFACE Assigning a Front-end Port to a Management VRF Starting in 9.7(0.0) release, you can assign a front-end port to a management VRF and make the port to act as a host interface. NOTE: You cannot assign loop-back and port-channel interfaces to a management port. To assign a front-end port to a management VRF, perform the following steps: Table 93. Assigning a Front-end port to a Management VRF Task Command Syntax Enter the front-end interface that you want to assign to a management interface. interface tengigabitethernet 1/1/1 Assign the interface to management VRF. ip vrf forwarding management Command Mode CONFIGURATION INTERFACE CONFIGURATION Virtual Routing and Forwarding (VRF) 1155