Dell C1048P Port Extender Networking Configuration Guide for the C9000 Series - Page 341

Running Port Extender Offline Diagnostics on the Switch To run port extender offline diagnostics on the switch: 1 Start the diagnostics on the unit. EXEC Privilege Mode diag pe pe-id stack-unit unit-number Specify the port extender ID and stack unit ID. • where pe-id is a port-extender group ID number from 0 to 255 • stack-unitunit-number is a PE stack-unit number from 0 to 7 Dell#diag pe 0 stack-unit 0 A warning is displayed with a CLI prompt asking you to click Yes or No. Dell#diag pe 0 stack-unit 0 level0 ? Warning - PE-Unit 0 at PEID 0 will go offline to run the diagnostics. Offline of system will bring down all the protocols and the system will be operationally down, except for running Diagnostics. PE unit will be automatically reloaded once the diagnostics tests are completed. Warning - The diagnostic execution will cause multiple link flaps on the peer side - advisable to shut directly connected ports Proceed with PE diag [confirm yes/no]:yes After completing the diagnostics on the PE, the PE reboots automatically reboots and then the switch and PE connection is established. The switch copies the diagnostic report file into the PE master flash. 2 Upload the diagnostics report file into the switch. EXEC Privilege mode show diag pe pe-id stack-unit unit-number This command copies the diagnostics report from the PE to the switch's flash. The name of the file that is copied is printed as part of the CLI output. For example: Dell#show diag pe 0 stack-unit 0 % Diag Report fileflash:/DEFAULT_DIAG_REPORT_DIR/TestReport-SU-0PE-0-20150312_045748.txt copied successfully. 3 View the results of the diagnostics test from the console. EXEC Privilege Mode show file file-name Debugging and Diagnostics 341