Dell C1048P Port Extender Networking Configuration Guide for the C9000 Series - Page 53

Table 2. Pin Assignments Between the Console and a DTE Terminal Server Console Port RJ-45 to RJ-45 Rollover Cable RJ-45 to RJ-45 Rollover Cable RJ-45 to DB-9 Adapter Signal RJ-45 Pinout RJ-45 Pinout DB-9 Pin RTS 1 8 8 NC 2 7 6 TxD 3 6 2 GND 4 5 5 GND 5 4 5 RxD 6 3 3 NC 7 2 4 CTS 8 1 7 Terminal Server Device Signal CTS DSR RxD GND GND TxD DTR RTS Mounting an NFS File System This feature enables you to quickly access data on an NFS mounted file system. You can perform file operations on an NFS mounted file system using supported file commands. This feature allows an NFS mounted device to be recognized as a file system. This file system is visible on the device and you can execute all file commands that are available on conventional file systems such as a Flash file system. Before executing any CLI command to perform file operations, you must first mount the NFS file system to a mount-point on the device. Since multiple mount-points exist on a device, it is mandatory to specify the mount-point to which you want to load the system. The /f10/mnt/nfsdirectory is the root of all mountpoints. To mount an NFS file system, perform the following steps: Table 3. Mounting an NFS File System File Operation Syntax To mount an NFS file system: mount nfs rhost:path mount-point username password The foreign file system remains mounted as long as the device is up and does not reboot. You can run the file system commands without having to mount or un-mount the file system each time you run a command. When you save the configuration using the write command, the mount command is saved to the startup configuration. As a result, each time the device re-boots, the NFS file system is mounted during start up. Getting Started 53