Dell C1048P Port Extender Networking Configuration Guide for the C9000 Series - Page 551

Configure Static Routes for the Management Interface When an IP address that a protocol uses and a static management route exists for the same prefix, the protocol route takes precedence over the static management route. To configure a static route for the management port, use the following command. • Assign a static route to point to the management interface or forwarding router. CONFIGURATION mode management route ip-address mask {forwarding-router-address | ManagementEthernet slot/port} Example of the show ip management-route Command To view the configured static routes for the management port, use the show ip management-route command in EXEC privilege mode. Dell#show ip management-route Destination ----------10.11.0.0/16 172.16.1.0/24 Gateway ------ManagementEthernet 0/0 10.11.198.4 State ----Connected Active Route Source -----------Connected Static Enabling Directed Broadcast By default, the system drops directed broadcast packets destined for an interface. This default setting provides some protection against denial of service (DoS) attacks. To enable the switch to receive directed broadcasts, use the following command. • Enable directed broadcast. INTERFACE mode ip directed-broadcast To view the configuration, use the show config command in INTERFACE mode. Resolution of Host Names Domain name service (DNS) maps host names to IP addresses. This feature simplifies commands such as Telnet and FTP by allowing you to enter a name instead of an IP address. Dynamic resolution of host names is disabled by default. Unless you enable the feature, the system resolves only host names entered into the host table with the ip host command. IPv4 Routing 551