Dell C1048P Port Extender Networking Configuration Guide for the C9000 Series - Page 42

Navigating CLI Modes The Dell Networking OS prompt changes to indicate the CLI mode. The following table lists the CLI mode, its prompt, and information about how to access and exit the CLI mode. Move linearly through the command modes, except for the following: • end command which takes you directly to EXEC Privilege mode • exit command which moves you up one command mode level NOTE: Sub-CONFIGURATION modes all have the letters "conf" in the prompt with more modifiers to identify the mode and slot/port information. Table 1. Command Modes CLI Command Mode EXEC EXEC Privilege CONFIGURATION NOTE: Access all the following modes from CONFIGURATION mode. Configuration Terminal Batch DOT1X PROFILE AS-PATH ACL 10 Gigabit Ethernet Interface 40 Gigabit Ethernet Interface Interface Range Loopback Interface Management Ethernet Interface Null Interface Prompt Dell> Dell# Dell(conf)# Access Command Access the router through the console or Telnet. • From EXEC mode, enter the enable command. • From any other mode, use the end command. • From EXEC privilege mode, enter the configure command. • From every mode except EXEC and EXEC Privilege, enter the exit command. Dell(conf-b)# dell(conf-dot1x-profile)# Dell(config-as-path)# Dell(conf-if-te-0/0)# Dell(conf-if-fo-0/0)# Dell(conf-if-range)# Dell(conf-if-lo-0)# Dell(conf-if-ma-0/0)# Dell(conf-if-nu-0)# config terminal batch dot1x ip as-path access-list interface (INTERFACE modes) interface (INTERFACE modes) interface (INTERFACE modes) interface (INTERFACE modes) interface (INTERFACE modes) interface (INTERFACE modes) Configuration Fundamentals 42