Dell C1048P Port Extender Networking Configuration Guide for the C9000 Series - Page 189

Examples of Viewing VRRP Sessions To view the established sessions, use the show bfd neighbors command. The following example shows viewing sessions with VRRP neighbors. The bold line shows that VRRP BFD sessions are enabled. R1(conf-if-te-4/25)#vrrp bfd all-neighbors R1(conf-if-te-4/25)#do show bfd neighbor * - Active session role Ad Dn - Admin Down C - CLI I - ISIS O - OSPF R - Static Route (RTM) V - VRRP LocalAddr RemoteAddr Interface State Rx-int Tx-int Mult Clients * 2.2.5.1 2.2.5.2 Te 4/25 Down 1000 1000 3 V To view session state information, use the show vrrp command. The following example shows viewing VRRP session state information. The bold line shows the VRRP BFD session. R1(conf-if-te-4/25)#do show vrrp TenGigabitEthernet 4/1, VRID: 1, Net: 2.2.5.1 State: Backup, Priority: 1, Master: 2.2.5.2 Hold Down: 0 sec, Preempt: TRUE, AdvInt: 1 sec Adv rcvd: 95, Bad pkts rcvd: 0, Adv sent: 933, Gratuitous ARP sent: 3 Virtual MAC address: 00:00:5e:00:01:01 Virtual IP address: 2.2.5.4 Authentication: (none) BFD Neighbors: RemoteAddr State 2.2.5.2 Up Changing VRRP Session Parameters BFD sessions are configured with default intervals and a default role. The parameters that you can configure are: Desired TX Interval, Required Min RX Interval, Detection Multiplier, and system role. You can change parameters for all VRRP sessions or for a particular neighbor. To change parameters for all VRRP sessions or for a particular VRRP session, use the following commands. • Change parameters for all VRRP sessions. INTERFACE mode vrrp bfd all-neighbors interval milliseconds min_rx milliseconds multiplier value role [active | passive] • Change parameters for a particular VRRP session. INTERFACE mode vrrp bfd neighbor ip-address interval milliseconds min_rx milliseconds multiplier value role [active | passive] Bidirectional Forwarding Detection (BFD) 189