Dell C1048P Port Extender Networking Configuration Guide for the C9000 Series - Page 764

• metric-type metric-type: 1 for OSPF external route type 1. 2 for OSPF external route type 2. • route-map map-name: enter a name of a configured route map. • tag tag-value: the range is from 0 to 4294967295. Example of Viewing OSPF Configuration after Redistributing Routes To view the current OSPF configuration, use the show running-config ospf command in EXEC mode or the show config command in ROUTER OSPF mode. Dell(conf-router_ospf)#show config ! router ospf 34 network 10.1.2.32 0.0.0.255 area 2.2.2.2 network 10.1.3.24 0.0.0.255 area 3.3.3.3 distribute-list dilling in Dell(conf-router_ospf)# Troubleshooting OSPFv2 Use the information in this section to troubleshoot OSPFv2 operation on the switch. Be sure to check the following, as these questions represent typical issues that interrupt an OSPFv2 process. NOTE: The following tasks are not a comprehensive list; they provide some examples of typical troubleshooting checks. • Have you enabled OSPF globally? • Is the OSPF process active on the interface? • Are adjacencies established correctly? • Are the interfaces configured for Layer 3 correctly? • Is the router in the correct area type? • Have the routes been included in the OSPF database? • Have the OSPF routes been included in the routing table (not just the OSPF database)? Some useful troubleshooting commands are: • show interfaces • show protocols • debug IP OSPF events and/or packets • show neighbors • show virtual links • show routes To help troubleshoot OSPFv2, use the following commands. • View the summary of all OSPF process IDs enables on the router. EXEC Privilege mode show running-config ospf • View the summary information of the IP routes. EXEC Privilege mode show ip route summary Open Shortest Path First (OSPFv2 and OSPFv3) 764