Dell C1048P Port Extender Networking Configuration Guide for the C9000 Series - Page 941

Configuration Task List The following is the configuration task list for RIP. • Enabling RIP Globally (mandatory) • Configure RIP on Interfaces (optional) • Controlling RIP Routing Updates (optional) • Setting Send and Receive Version (optional) • Generating a Default Route (optional) • Controlling Route Metrics (optional) • Summarize Routes (optional) • Controlling Route Metrics • Debugging RIP For a complete listing of all commands related to RIP, refer to the Dell Networking OS Command Reference Interface Guide. Enabling RIP Globally By default, RIP is disabled on the switch. To enable RIP globally, use the following commands. 1 Enter ROUTER RIP mode and enable the RIP process. CONFIGURATION mode router rip 2 Assign an IP network address as a RIP network to exchange routing information. ROUTER RIP mode network ip-address Examples of Viewing RIP Information After designating networks with which the system is to exchange RIP information, ensure that all devices on that network are configured to exchange RIP information. The system default is to send RIPv1 and to receive RIPv1 and RIPv2. To change the RIP version globally, use the version command in ROUTER RIP mode. To view the global RIP configuration, use the show running-config command in EXEC mode or the show config command in ROUTER RIP mode. Dell(conf-router_rip)#show config ! router rip network 10.0.0.0 Dell(conf-router_rip)# Routing Information Protocol (RIP) 941