Dell C1048P Port Extender Networking Configuration Guide for the C9000 Series - Page 203

When configuring this functionality: • If the redistribute command does not have metric configured and the BGP peer outbound routemap does have metric-type internal configured, BGP advertises the IGP cost as MED. • If the redistribute command has metric configured (route-map set metric or redistribute route-type metric) and the BGP peer outbound route-map has metric-type internal configured, BGP advertises the metric configured in the redistribute command as MED. • If BGP peer outbound route-map has metric configured, all other metrics are overwritten by this configuration. NOTE: When redistributing static, connected, or OSPF routes, there is no metric option. Simply assign the appropriate route-map to the redistributed route. The following table lists some examples of these rules. Table 8. Redistributed Route Rules Command Settings BGP Local Routing Information Base redistribute isis (IGP cost = 20) redistribute isis routemap set metric 50 redistribute isis metric 100 MED: IGP cost 20 MED: IGP cost 50 MED: IGP cost 100 MED Advertised to Peer MED Advertised to Peer WITH route-map metric- WITHOUT route-map type internal metric-type internal MED = 20 MED = 0 MED: 50 MED: 50 MED: 50 MED: 50 MED: 100 MED: 100 Ignore Router-ID for Some Best-Path Calculations You can avoid unnecessary BGP best-path transitions between external paths under certain conditions. The bgp bestpath router-id ignore command reduces network disruption caused by routing and forwarding plane changes and allows for faster convergence. Four-Byte AS Numbers The 4-Byte (32-bit) format is supported to configure autonomous system numbers (ASNs). The 4-Byte support is advertised as a new BGP capability (4-BYTE-AS) in the OPEN message. If a 4-Byte BGP speaker has sent and received this capability from another speaker, all the messages will be 4-octet. The behavior of a 4-Byte BGP speaker is different with the peer depending on whether the peer is a 4-Byte or 2Byte BGP speaker. Where the 2-Byte format is 1-65535, the 4-Byte format is 1-4294967295. Enter AS numbers using the traditional format. If the ASN is greater than 65535, the dot format is shown when using the show ip bgp commands. For example, an ASN entered as 3183856184 appears in the show commands as 48581.51768; an ASN of 65123 is shown as 65123. To calculate the comparable dot format for an ASN from a traditional format, use ASN/65536. ASN%65536. Border Gateway Protocol IPv4 (BGPv4) 203