Dell C1048P Port Extender Networking Configuration Guide for the C9000 Series - Page 725

Location Receiver 2 Description • Interface VLAN 400 • ip pim sparse-mode • ip address 10.11.4.1/24 • untagged GigabitEthernet 1/2 • ip igmp access-group igmpjoinfilR2G2 • no shutdown Rate Limiting IGMP Join Requests If you expect a burst of IGMP Joins, protect the IGMP process from overload by limiting that rate at which new groups can be joined. Hosts whose IGMP requests are denied will use the retry mechanism built-in to IGMP so that they're membership is delayed rather than permanently denied. • Limit the rate at which new groups can be joined. INTERFACE mode ip igmp group-join-limit To view the enable status of this feature, use the show ip igmp interface command from EXEC Privilege mode. Preventing a PIM Router from Forming an Adjacency To prevent a router from participating in PIM (for example, to configure stub multicast routing), use the following command. • Prevent a router from participating in protocol independent multicast (PIM). INTERFACE mode ip pim neighbor-filter Preventing a Source from Registering with the RP To prevent the PIM source DR from sending register packets to RP for the specified multicast source and group, use the following command. If the source DR never sends register packets to the RP, no hosts can ever discover the source and create a shortest path tree (SPT) to it. • Prevent a source from transmitting to a particular group. CONFIGURATION mode ip pim register-filter In the following example, Source 1 and Source 2 are both transmitting packets for groups 239.0.0.1 and 239.0.0.2. R3 has a PIM register filter that only permits packets destined for group 239.0.0.2. An entry is created for group 239.0.0.1 in the routing table, but no outgoing interfaces are listed. R2 has no filter, so it is Multicast Features 725