Dell C1048P Port Extender Networking Configuration Guide for the C9000 Series - Page 807

• Create a Rule for a Redirect-list • Create a Track-id list. For complete tracking information, refer to Object Tracking chapter. • Apply a Redirect-list to an Interface using a Redirect-group Create a Redirect List Use the following command in CONFIGURATION mode: Table 62. Create a Redirect List Command Syntax Command Mode Purpose ip redirect-list redirect-list- CONFIGURATION name Create a redirect list by entering the list name. Format: 16 characters Delete the redirect list with the no ip redirect-list command. The following example creates a redirect list by the name of "xyz." Dell(conf)#ip redirect-list ? WORD Redirect-list name (max 16 chars) Dell(conf)#ip redirect-list xyz Create a Rule for a Redirect-list Use the following command in CONFIGURATION REDIRECT-LIST mode to set the rules for the redirect list. You can enter the command multiple times and create a sequence of redirect rules. Use the seq nn redirect version of the command to organize your rules. Table 63. Create a Rule for a Redirect-list Command Syntax Comma Purpose nd Mode {seq sequencenumber} redirect {ip-address| tunnel tunnel-id} [track obj-id] {protocol-type} {source mask | any | host ip-address} {destination mask | any | host ipaddress} [bit] [operators]} REDIRE Configure a rule for the redirect list. CT-LIST ip-address is the forwarding router's address tunnel - keyword to configure the tunnel settings. tunnel-id is used to redirect the traffic. Protocol-type - Enter one of the following keywords as the protocol type • icmp for Internet Control Message Protocol • ip for Any Internet Protocol • tcp for Transmission Control Protocol • udp for User Datagram Protocol Optional Policy-based Routing (PBR) 807