Dell C1048P Port Extender Networking Configuration Guide for the C9000 Series - Page 511

• Configure an IP address. INTERFACE mode ip address • Enable the interface. INTERFACE mode no shutdown • The interface is the management interface. INTEFACE mode description Example of the show interface and show ip route Commands To display the configuration for a given port, use the show interface command in EXEC Privilege mode, as shown in the following example. To display the routing table, use the show ip route command in EXEC Privilege mode. Dell#show int fortyGigE 2/12 fortyGigE 2/12 is up, line protocol is up Hardware is DellEth, address is 74:86:7a:ff:6f:48 Current address is 74:86:7a:ff:6f:48 Pluggable media present, QSFP type is 40GBASE-CR4-1M Interface index is 154288642 Internet address is 6.1.1.1/24 Mode of IPv4 Address Assignment : MANUAL [output omitted] Dell#show ip route Codes: C - connected, S - static, R - RIP, B - BGP, IN - internal BGP, EX - external BGP,LO - Locally Originated, O - OSPF, IA - OSPF inter area, N1 - OSPF NSSA external type 1, N2 - OSPF NSSA external type 2, E1 - OSPF external type 1, E2 - OSPF external type 2, i - IS-IS, L1 - IS-IS level-1, L2 - IS-IS level-2, IA - IS-IS inter area, * - candidate default, > - non-active route, + - summary route Gateway of last resort is not set Destination ----------C 6.1.1.0/24 C 10.1.1.0/24 *S 0.0.0.0/0 00:01:12 Dell# Gateway ------Direct, Fo 2/12 Direct, Vl 10 via 6.1.1.1, Fo 2/12 Dist/Metric Last Change 0/0 00:01:12 0/0 01:09:08 0/0 Port Extender Interfaces You can use a C9010 switch with an attached C1048P port extender (PE) to expand the port density of the chassis. In this configuration, the C9010 operates as a controlling bridge for the C1048P. The C1048P functions as a remote line card that is physically connected to, and automatically provisioned by, a C9010 over 10GE links according to the IEEE 802.1BR standard. Interfaces 511