Dell C1048P Port Extender Networking Configuration Guide for the C9000 Series - Page 1156

Task Command Syntax NOTE: Before assigning a front-end port to a management VRF, ensure that no IP address is configured on the interface. Assign an IPv4 address to the interface. NOTE: You can assign either an IPv4 or an IPv6 address but not both. ip address 10.1.1.1/24 Assign an IPv6 address to the interface. NOTE: You can also auto configure an IPv6 address using the ipv6 address autoconfig command. ipv6 address 1::1 Command Mode INTERFACE CONFIGURATION INTERFACE CONFIGURATION View VRF Instance Information To display information about VRF configuration, enter the show ip vrf command. Task Command Syntax Command Mode Display the interfaces assigned to a show ip vrf [vrf-name] VRF instance. To display information on all VRF instances (including the default VRF 0), do not enter a value for vrf-name. EXEC Assigning an OSPF Process to a VRF Instance OSPF routes are supported on all VRF instances. Refer to for complete OSPF configuration information. Assign an OSPF process to a VRF instance . Return to CONFIGURATION mode to enable the OSPF process. The OSPF Process ID is the identifying number assigned to the OSPF process, and the Router ID is the IP address associated with the OSPF process. Task Enable the OSPFv2 process globally for a VRF instance. Enter the VRF key word and instance name to tie the OSPF instance to the VRF. All network commands under this OSPF instance are subsequently tied to the VRF Command Syntax Command Mode router ospf process-id vrf CONFIGURATION vrf name Virtual Routing and Forwarding (VRF) 1156