Dell C1048P Port Extender Networking Configuration Guide for the C9000 Series - Page 974

Example: Allow Security Administrator to Access Only 10-Gigabit Ethernet Interfaces The following example allows the security administrator (secadmin) to only access 10-Gigabit Ethernett interfaces and then shows that the secadmin, highlighted in bold, can now access Interface mode. However, the secadmin can only access 10-Gigabit Ethernet interfaces. Dell(conf)#role configure addrole secadmin ? LINE Initial keywords of the command to modify Dell(conf)#role configure addrole secadmin interface tengigabitethernet Dell(conf)#show role mode configure interface Role access: netadmin, secadmin, sysadmin Example: Verify that the Security Administrator Can Access Interface Mode The following example shows that the secadmin role can now access Interface mode (highlighted in bold). Role Inheritance Modes netoperator netadmin secadmin sysadmin Exec Config Interface Router IP RouteMap Protocol MAC Exec Config Interface Line Exec Config Interface Line Router IP RouteMap Protocol MAC Example: Remove Security Administrator Access to Line Mode. The following example removes the secadmin access to LINE mode and then verifies that the security administrator can no longer access LINE mode, using the show role mode configure line command in EXEC Privilege mode. Dell(conf)#role configure deleterole secadmin ? LINE Initial keywords of the command to modify Dell(conf)#role configure deleterole secadmin line Dell(conf)#do show role mode ? configure Global configuration mode exec Exec Mode interface Interface configuration mode line Line Configuration mode route-map Route map configuration mode router Router configuration mode Dell(conf)#do show role mode configure line Role access:sysadmin Example: Grant and Remove Security Administrator Access to Configure Protocols By default, the system defined role, secadmin, is not allowed to configure protocols. The following example first grants the secadmin role to configure protocols and then removes access to configure protocols. Dell(conf)#role configure addrole secadmin protocol Dell(conf)#role configure deleterole secadmin protocol Example: Resets Only the Security Administrator role to its original setting. The following example resets only the secadmin role to its original setting. Dell(conf)#no role configure addrole secadmin protocol Example: Reset System-Defined Roles and Roles that Inherit Permissions Security 974