Dell C1048P Port Extender Networking Configuration Guide for the C9000 Series - Page 751

Number of area in this router is 1, normal 0 stub 0 nssa 1 --More-- OSPF ACK Packing The OSPF ACK packing feature bundles multiple LS acknowledgements in a single packet, significantly reducing the number of ACK packets transmitted when the number of LSAs increases. This feature also enhances network utilization and reduces the number of small ACK packets sent to a neighboring router. OSPF ACK packing is enabled by default and non-configurable. Setting OSPF Adjacency with Cisco Routers To establish an OSPF adjacency between Dell Networking and Cisco routers, the hello interval and dead interval must be the same on both routers. The OSPF dead interval value is, by default, set to 40 secondsand is independent of the OSPF hello interval. Configuring a hello interval does not change the dead interval in the system. In contrast, the OSPF dead interval on a Cisco router is, by default, four times as long as the hello interval. Changing the hello interval on the Cisco router automatically changes the dead interval. To ensure equal intervals between the routers, use the following command. • Manually set the dead interval of the Dell Networking router to match the Cisco configuration. INTERFACE mode ip ospf dead-interval Examples of Setting and Viewing a Dead Interval In the following example, the dead interval is set at 4x the hello interval (shown in bold). Dell(conf)#int te 2/2 Dell(conf-if-te-2/2)#ip ospf hello-interval 20 Dell(conf-if-te-2/2)#ip ospf dead-interval 80 Dell(conf-if-te-2/2)# In the following example, the dead interval is set at 4x the hello interval (shown in bold). Dell (conf-if-te-2/2)#ip ospf dead-interval 20 Dell (conf-if-te-2/2)#do show ip os int te 1/3 TengigabitEthernet 2/2 is up, line protocol is up Internet Address 20.0.0.1/24, Area 0 Process ID 10, Router ID 1.1.1.2, Network Type BROADCAST, Cost: 1 Transmit Delay is 1 sec, State DR, Priority 1 Designated Router (ID) 1.1.1.2, Interface address 30.0.0.1 Backup Designated Router (ID) 1.1.1.1, Interface address 30.0.0.2 Timer intervals configured, Hello 20, Dead 80, Wait 20, Retransmit 5 Hello due in 00:00:04 Neighbor Count is 1, Adjacent neighbor count is 1 Adjacent with neighbor 1.1.1.1 (Backup Designated Router) Dell(conf-if-te-2/2)# Open Shortest Path First (OSPFv2 and OSPFv3) 751