Dell C1048P Port Extender Networking Configuration Guide for the C9000 Series - Page 990

• level level: the range is from 0 to 15. Levels 0, 1, and 15 are pre-configured. Levels 2 to 14 are available for custom configuration. • command: a CLI keyword (up to five keywords allowed). • reset: return the command to its default privilege mode. Examples of Custom Privilege Level Commands To view the configuration, use the show running-config command in EXEC Privilege mode. The following example shows a configuration to allow a user john to view only EXEC mode commands and all snmp-server commands. Because the snmp-server commands are enable level commands and, by default, found in CONFIGURATION mode, also assign the launch command for CONFIGURATION mode, configure, to the same privilege level as the snmp-server commands. Line 1: The user john is assigned privilege level 8 and assigned a password. Line 2: All other users are assigned a password to access privilege level 8. Line 3: The configure command is assigned to privilege level 8 because it needs to reach CONFIGURATION mode where the snmp-server commands are located. Line 4: The snmp-server commands, in CONFIGURATION mode, are assigned to privilege level 8. Dell(conf)#username john privilege 8 password john Dell(conf)#enable password level 8 notjohn Dell(conf)#privilege exec level 8 configure Dell(conf)#privilege config level 8 snmp-server Dell(conf)#end Dell#show running-config Current Configuration ... ! hostname Force10 ! enable password level 8 notjohn enable password Force10 ! username admin password 0 admin username john password 0 john privilege 8 ! The following example shows the Telnet session for user john. The show privilege command output confirms that john is in privilege level 8. In EXEC Privilege mode, john can access only the commands listed. In CONFIGURATION mode, john can access only the snmp-server commands. apollo% telnet 172.31.1.53 Trying 172.31.1.53... Connected to 172.31.1.53. Escape character is '^]'. Login: john Password: Dell#show priv Current privilege level is 8 Dell#? configure Configuring from terminal disable Turn off privileged commands enable Turn on privileged commands exit Exit from the EXEC no Negate a command show Show running system information terminal Set terminal line parameters traceroute Trace route to destination Security 990