Dell GX240 User's Guide - Page 200

www.dell.com | support.dell.com Computer Messages Message Plug and Play Configuration Error Read fault Requested sector not found Reset failed Sector not found Seek error Shutdown failure Time-of-day clock stopped Cause Action The computer has encountered a problem in trying to configure one or more expansion cards. Turn your computer off and unplug it. Remove all but one of the cards. Plug in your computer and reboot it. If the problem persists, the expansion card may be malfunctioning. If the message does not reappear, turn off the power and reinsert one of the other cards. Repeat this process until you identify the malfunctioning card. The operating system cannot read from the floppy or hard drive. See "Floppy Drive Problems" or "Hard Drive Problems." The computer could not find a particular sector on the disk, or the requested sector is defective. The disk reset operation failed. See "Floppy Drive Problems" or "Hard Drive Problems." The operating system is See "Floppy Drive unable to locate a sector Problems" or "Hard Drive on the floppy or hard drive. Problems." The operating system is If the error is on the floppy unable to find a specific drive, try another floppy in track on the floppy or hard the drive. drive. A chip on the system board Run the System Board might be malfunctioning. Devices tests in the Dell Diagnostics. The battery may be dead. Enter system setup and correct the date or time. If the problem persists, see "Battery Problems." 198 Solving Problems