Dell GX280DT User Guide - Page 125
Small Desktop Computer
UPC - 851846002006
View all Dell GX280DT manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 125 highlights
NOTICE: To connect a network cable, first plug the cable into the network wall jack and then plug it into the computer. 11. Connect your computer and devices to electrical outlets, and turn them on. Small Desktop Computer CAUTION: Before you begin any of the procedures in this section, follow the safety instructions located in the Product Information Guide. 1. Follow the procedures in "Before You Begin." 2. Disconnect the DC power cables from the system board and the drives. Note the routing of the DC power cables underneath the tabs in the computer frame as you remove them from the system board and drives. You must route these cables properly when you replace them to prevent their being pinched or crimped. 3. Remove the card cage and remove the power cables from the side of the hard drive. To remove the power cables, use the cables as leverage and pull away from the clips while you pull on the metal clips with your fingers. 4. Press down on the handle, which in turn presses the release button. 1 release button 2 handle 3 AC power connector 5. Slide the power supply toward the front of the computer approximately 1 inch. 6. Lift the power supply up and out of the computer. 7. Slide the replacement power supply into place. 8. Reconnect the DC power cables. 9. Replace the card cage. 10. Connect the AC power cable to the connector. 11. Close the computer cover. 12. Attach the computer stand, if used. NOTICE: To connect a network cable, first plug the cable into the network wall jack and then plug it into the computer. 13. Connect your computer and devices to electrical outlets, and turn them on.