Dell GX280DT User Guide - Page 183
Installing a CD/DVD Drive
UPC - 851846002006
View all Dell GX280DT manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 183 highlights
1. Disconnect the power and CD/DVD drive cables from the back of the drive. 2. Disconnect the other end of the CD/DVD drive cable from the IDE connector on the system board. 1 power cable 2 CD/DVD drive cable 3 IDE connector 3. Press inward on the two tabs on the sides of the drive, and then slide the drive upward and remove it from the drive bay. Installing a CD/DVD Drive 1. Unpack the drive and prepare it for installation. Check the documentation that accompanied the drive to verify that the drive is configured for your computer. If you are installing an IDE drive, configure the drive for the cable select setting. 2. If the replacement drive does not have the bracket rails attached, remove the rails from the old drive by removing the two screws that secure each rail to the drive. Attach the bracket to the new drive by aligning the screw holes on the drive with the screw holes on the bracket rails and then inserting and tightening all four screws (two screws on each rail).