Dell Precision 490 Desktop User's Guide - Page 58

1 sliding-plate lever 2 optional third hard drive in FlexBay 9. Set the drive aside in a secure location. NOTICE: If metal shields are present in your computer configuration, they must be installed at all times while your computer is in use or your computer may not function properly. 10. If you are not installing another drive in the drive bay, If metal shields are present in your computer (see About the Metal Shields Present in Some Drive Configurations): reinstall the vented metal insert over the FlexBay and the empty space beneath it. a. Insert the metal insert's two upper screws and its two lower screws into the corresponding slots inside the FlexBay. b. Push the vented metal insert until it clicks into place and its metal tabs rest flush against the chassis surface. Install a drive-panel insert (see Replacing a Drive-Panel Insert). 11. Reinstall the drive panel (see Replacing the Drive Panel). 12. Ensure that all connectors are properly cabled and firmly seated. 13. Replace the computer cover (see Replacing the Computer Cover). NOTICE: To connect a network cable, first plug the cable into the network port or device and then plug it into the computer. 14. Connect the computer and devices to electrical outlets, and turn them on. Installing an Optional Third Hard Drive (Tower Computer Only) CAUTION: Before you begin any of the procedures in this section, follow the safety instructions in the Product Information Guide. CAUTION: To guard against electrical shock, always unplug your computer from the electrical outlet before opening the cover. NOTICE: To prevent static damage to components inside your computer, discharge static electricity from your body before you touch any of your computer's electronic components. You can do so by touching an unpainted metal surface on the computer. NOTICE: To avoid damage to the hard drive, do not set it on a hard surface. Instead, set the drive on a surface, such as a foam pad, that will sufficiently cushion it. 1. If you are installing a new drive, unpack the drive and prepare it for installation. Check the documentation for the drive to verify that it is configured for your computer. NOTE: The screws installed in the following step must be installed in the front four screw holes in order for the drive to be installed. 2. Install 4 screws in the front four holes on the sides of the drive, if they are not already installed. Otherwise, verify that the screws are installed in the front 4 holes. 3. Follow the procedures in Before You Begin.