Dell Precision T5400 User's Guide - Page 222
FlexBay, remove it see Removing a Floppy Drive Tower Computer
View all Dell Precision T5400 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 222 highlights
NOTE: The screws installed in the following step must be installed in the front four screw holes in order for the drive to be installed. 2 Install 4 screws in the front four holes on the sides of the drive, if they are not already installed. Otherwise, verify that the screws are installed in the front 4 holes. 3 Follow the procedures in "Before You Begin" on page 151. 4 Remove the computer cover (see "Removing the Computer Cover" on page 153). 5 Remove the drive panel (see "Removing the Drive Panel" on page 233). NOTICE: If metal shields are present in your computer configuration, they must be installed at all times while your computer is in use or your computer may not function properly. 6 If the FlexBay is not populated and metal shields are present in your computer (see "About the Metal Shields Present in Some Drive Configurations" on page 207 for more information), slide the sliding-plate lever to the right and hold it in place as you pull to remove the vented metal insert from the FlexBay. 7 If you already have a floppy drive or Media Card Reader installed in the FlexBay, remove it (see "Removing a Floppy Drive (Tower Computer)" on page 240 or "Removing a Media Card Reader (Tower Computer)" on page 254). 8 If you already have a hard drive installed in the FlexBay, remove the hard drive (see "Removing an Optional Third Hard Drive (Tower Computer Only)" on page 218). 9 Gently slide the drive into place in the FlexBay; the drive clicks through two notches before it is securely installed. 222 Adding and Replacing Parts