Dell Precision T5400 User's Guide - Page 35
Holding the metal insert at an angle, insert its two upper screws into
View all Dell Precision T5400 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 35 highlights
13 If you had a hard drive installed in the 5.25-inch bay and you are changing from a desktop to a tower configuration, remove the hard drive from the drive carrier and install four screws into the front four holes on the sides of the heard drive. If you had a hard drive installed in the FlexBay and you are changing from a tower to a desktop configuration, remove its four screws and install the hard drive into the drive carrier (see "Hard Drive" on page 212). NOTE: Hard-drive screws or a hard-drive carrier can be ordered from Dell. See "Contacting Dell" on page 295. 14 If metal shields are present in your computer (see "About the Metal Shields Present in Some Drive Configurations" on page 207), replace metal shields in any empty optical drive bays or over the FlexBay, in tower mode only, by pressing them into place. 15 If a vented metal insert was installed over the FlexBay and you are converting from tower to desktop mode, reinstall it: a Holding the metal insert at an angle, insert its two upper screws into the slot that runs along the inside of the FlexBay. b Rotate the bottom of the vented metal insert down and insert its two bottom screws into the slot in the open area beneath the FlexBay. c Push the vented metal insert until it clicks into place and its metal tabs rest flush against the chassis surface. About Your Computer 35