Dell Precision T5400 User's Guide - Page 248
bottom screws into the slot in the open area beneath the FlexBay.
View all Dell Precision T5400 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 248 highlights
1 2 1 drive retention insert 2 floppy drive 7 Remove the floppy drive from the FlexBay. 8 If you are not installing another drive in the FlexBay, and metal shields are present in your computer (see "About the Metal Shields Present in Some Drive Configurations" on page 207), install the vented metal insert over the FlexBay and the empty space beneath it: a Holding the metal insert at an angle, insert its two upper screws into the slot that runs along the inside of the FlexBay. b Rotate the bottom of the vented metal insert down and insert its two bottom screws into the slot in the open area beneath the FlexBay. c Push the vented metal insert until it clicks into place and its metal tabs rest flush against the chassis surface. Then, install a drive-panel insert (see "Replacing a Drive-Panel Insert" on page 236). 248 Adding and Replacing Parts