Dell Precision T5400 User's Guide - Page 225

a Insert the metal insert's two upper screws and its two lower screws into the corresponding slots inside the FlexBay. b Push the vented metal insert until it clicks into place and its metal tabs rest flush against the chassis surface. 13 Reinstall the drive panel (see "Replacing the Drive Panel" on page 237). 14 Ensure that all connectors are properly cabled and firmly seated. 15 Replace the computer cover (see "Replacing the Computer Cover" on page 161). NOTICE: To connect a network cable, first plug the cable into the network port or device and then plug it into the computer. 16 Connect the computer and devices to electrical outlets, and turn them on. See the documentation that came with the drive for instructions on installing any software required for drive operation. 17 If the drive you just installed is the primary drive, insert bootable media into drive A. 18 Turn on the computer. 19 Enter the system setup program (see "System Setup" on page 89) and update the appropriate Drive option. 20 Exit the system setup program, and reboot the computer. 21 Partition and logically format your drive before you proceed to the next step. See the documentation for your operating system for instructions. 22 Test the hard drive. See "Dell Diagnostics" on page 136 for instructions. 23 If the drive you just installed is the primary drive, install your operating system on the hard drive. Removing an Optional SATA Third Hard Drive (Desktop Computer Only) CAUTION: Before you begin any of the procedures in this section, follow the safety instructions located in the Product Information Guide. CAUTION: To guard against electrical shock, always unplug your computer from the electrical outlet before removing the cover. 1 Follow the procedures in "Before You Begin" on page 151. Adding and Replacing Parts 225