Dell Unity XT 480 Unity All Flash and Unity Hybrid Unity 480/F Unity 680/F Uni - Page 42
Remove a faulted embedded module, Table 4. Embedded module LEDs continued
View all Dell Unity XT 480 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 42 highlights
Table 4. Embedded module LEDs (continued) LED Location Ethernet port link Ethernet port activity SAS port/activity Link Port link Storage processor assembly fault Storage processor assembly power Unsafe to remove State Off Green Off Amber blinking Off Blue Off Green Amber Off Amber Blue Amber or blue blinking Blue and amber alternating (green for 3 seconds) Blue and amber alternating at one second intervals Off Green Green blinking Off White Off Description No fault has occurred, normal operation. Link established. No link established. Port activity. No port activity. SAS port link is up. No link established. Link up with high speed. Link up with degraded speed. Link down. Fault has occurred. Storage processor assembly in Degraded Mode. System is booting. System not initialized. A management IP address has not been assigned. Storage processor assembly in Service Mode. No fault has occurred, normal operation. Storage processor assembly is on (main power). Storage processor assembly is initializing a serial over LAN session. Storage processor assembly is off. Do not remove the SP assembly. Improper removal could cause data loss. Safe to remove the SP assembly or embedded module when the SP assembly or embedded module has been properly prepared. Remove a faulted embedded module Steps 1. Label and disconnect all cables attached to the embedded module. 2. Push the orange tab to release the lever. 42 Service Procedures