Dell Unity XT 480 Unity All Flash and Unity Hybrid Unity 480/F Unity 680/F Uni - Page 63

Install a new I/O module, Removing the I/O module, Installing an I/O module

Get Dell Unity XT 480 PDF manuals and user guides View all Dell Unity XT 480 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 63 highlights

Figure 65. Removing the I/O module Install a new I/O module Steps 1. Align the module with the empty slot and carefully push the module into the slot. Figure 66. Installing an I/O module 2. When the I/O module appears seated, push and release the small button on the handle. ● If the button remains in, the module is fully seated. ● If the button springs back, gently push the module further into the chassis, then push it again. ● If the button still does not rest flush with its handle, remove the module and repeat steps 1 and 2. Figure 67. Locking in the I/O module 3. Connect the cables into the assigned I/O module ports. Service Procedures 63

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
  • 68
  • 69
  • 70
  • 71
  • 72
  • 73
  • 74
  • 75
  • 76
  • 77
  • 78
  • 79
  • 80
  • 81
  • 82
  • 83
  • 84
  • 85
  • 86
  • 87
  • 88
  • 89
  • 90
  • 91
  • 92
  • 93
  • 94
  • 95
  • 96
  • 97
  • 98
  • 99
  • 100
  • 101
  • 102
  • 103
  • 104
  • 105
  • 106
  • 107
Figure 65. Removing the I/O module
Install a new I/O module
Steps
1.
Align the module with the empty slot and carefully push the module into the slot.
Figure 66. Installing an I/O module
2.
When the I/O module appears seated, push and release the small button on the handle.
●
If the button remains in, the module is fully seated.
●
If the button springs back, gently push the module further into the chassis, then push it again.
●
If the button still does not rest flush with its handle, remove the module and repeat steps 1 and 2.
Figure 67. Locking in the I/O module
3.
Connect the cables into the assigned I/O module ports.
Service Procedures
63