Dell Unity XT 480 Unity All Flash and Unity Hybrid Unity 480/F Unity 680/F Uni - Page 45
Install an embedded module
View all Dell Unity XT 480 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 45 highlights
2. Align the white pegs beneath the holes on the 4-port card. CAUTION: Do not force the 4-port card into place. If the 4-port card does not smoothly seat, re-align the pegs and try again. Figure 41. Seating the 4-port card 3. Gently push down on the upper-left circle on the 4-port card. 4. Push up on the blue tabs until they lock into place. Figure 42. Locking the 4-port card into position 5. Replace the air dam and tighten the four captive screws. 6. Install the SFPs into the embedded module. Install an embedded module Steps 1. Align the embedded module with the empty slot and carefully push it into the slot. As the embedded module is installed, the release lever rotates inward. Service Procedures 45
2.
Align the white pegs beneath the holes on the 4-port card.
CAUTION:
Do not force the 4-port card into place. If the 4-port card does not smoothly seat, re-align the
pegs and try again.
Figure 41. Seating the 4-port card
3.
Gently push down on the upper-left circle on the 4-port card.
4.
Push up on the blue tabs until they lock into place.
Figure 42. Locking the 4-port card into position
5.
Replace the air dam and tighten the four captive screws.
6.
Install the SFPs into the embedded module.
Install an embedded module
Steps
1.
Align the embedded module with the empty slot and carefully push it into the slot.
As the embedded module is installed, the release lever rotates inward.
Service Procedures
45