Denon AVR-3312CI AVR3312CI_OwnersManual - Page 23
Connecting an external control device, REMOTE CONTROL jacks, RS-232C connector, TRIGGER OUT jacks
UPC - 883795002042
View all Denon AVR-3312CI manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 23 highlights
Basic version Connecting an external control device REMOTE CONTROL jacks If this unit is installed in a location that is out of range of the signal from the remote control unit, you can still operate the unit and the devices connected to it by using a commercially available IR receiver. You can also use it to remotely control ZONE2, ZONE3 (another room). Infrared retransmitter Infrared sensor AUX Input OUT Output Device equipped with a REMOTE CONTROL IN jack RS-232C connector When you connect an external control device, you can control this unit with the external control device. External serial controller TRIGGER OUT jacks When a device with TRIGGER IN jack is connected, the connected device's power on/standby can be controlled through linked operation to this unit. The TRIGGER OUT jack outputs a maximum 12 V/150 mA electrical signal. 12 V/150 mA trigger-compatible device Advanced version Information Perform the operation below beforehand. q Turn on the power of this unit. w Turn off the power of this unit from the external controller. e Check that the unit is in the standby mode. in Set as Necessary Set to change the conditions for linked operation via the TRIGGER OUT 1 or 2 jack. "Trigger Out 1" or "Trigger Out 2" (vpage 117) NOTE • Use the monaural mini-plug cable for connecting TRIGGER OUT jacks. Do not use the stereo mini-plug cable. • If the permissible trigger input level for the connected device is larger than 12 V/150 mA, or has shorted, the TRIGGER OUT jack cannot be used. In this case, turn off the power to the unit, and disconnect it. 20