Denon AVR-3312CI AVR3312CI_OwnersManual - Page 28
Store, Finish, Check - audio return channel
UPC - 883795002042
View all Denon AVR-3312CI manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 28 highlights
Basic version Advanced version STEP 5 Check STEP 6 Store Finish Set up speakers (Audyssey® Auto Setup) 12 Use ui to select the item you want to check, and then press ENTER. 14 Select "Store" and then press ENTER. Save the measurement results. AUDYSSEY AUTO SETUP STEP6 Store 1 2 3 4 5 6 Press "Store" to store calculation results. AUDYSSEY AUTO SETUP STEP5 Check Check processing results. To proceed, press "Next". 1 2 3 4 5 6 Speaker Config. Check Distance Check Channel Level Check Crossover Freq. Check Next Store Enter Proceed to next (Store) RETURN Cancel • Subwoofers may measure a greater reported distance than the actual distance due to added electrical delay common in subwoofers. • If you want to check another item, press RETURN B. 13 Use i to select "Next → Store" and then press ENTER. Store Enter RETURN Cancel Apply and store measurement result AUDYSSEY AUTO SETUP STEP6 Store Now storing...Please wait. 20% 1 2 3 4 5 6 NOTE • If the result differs from the actual connection status, or if "Caution!" is displayed, see "Error messages" (vpage 26). Then carry out Audyssey® Auto Setup again. • If you change speaker positions or orientation, perform Audyssey® Auto Setup again to find the optimal equalizer settings. • Saving the results requires about 10 seconds. • If the measuring results are not to be saved, press RETURN B. A message "Cancel auto setup?" will be displayed. Press o then select "Yes". All the measured Audyssey® Auto Setup data will be erased. • During saving of measurements results, "Now storing...Please wait." is displayed. When saving is completed, "Storing complete. Auto Setup is now finished." is displayed. NOTE During saving of measurement results, be sure not to turn off the power. 15 Unplug the setup microphone from the unit's SETUP MIC jack. 16 Set Audyssey Dynamic Volume®. AUDYSSEY AUTO SETUP Finish Storing complete. Auto Setup is now finished. Please unplug microphone. Turn on Dynamic Volume? 1 2 3 4 5 6 Yes No Exit Turn Dynamic Volume off and exit Auto Setup • This feature adjusts the output volume to the optimal level while constantly monitoring the level of the audio input to the unit. Optimal volume control is performed automatically without any loss in the dynamism and clarity of the sound when, for example, the volume suddenly increases for commercials shown during television programs. nn When turning Dynamic Volume® on • Use u to select "Yes", and then press ENTER. The unit automatically enters "Evening" mode. nn When turning Dynamic Volume® off • Use i to select "No", and then press ENTER. NOTE After performing Audyssey® Auto Setup, do not change the speaker connections or subwoofer volume. In event of a change, perform Audyssey® Auto Setup again. Information 25