Epson Stylus Pro 7600 - UltraChrome Ink Service Manual - Page 166
Rear Cover
View all Epson Stylus Pro 7600 - UltraChrome Ink manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 166 highlights
EPSON Stylus Pro 7600/9600 4.2.6 Rear Cover 1. From the rear side, remove two screws (CPS: M3×12), and remove the blank panel. (See Figure 4-16) 2. Remove the two screws (CP: M3×6) securing the parallel interface and remove the one screw (CBS: M3×6) securing the USB interface. 3. Remove one screw (CBS: M3×6) holding the AC inlet top. (See Figure 4-17) 4. Remove the three screws (CBS: M4×8) (six screws for Stylus Pro 9600) holding the rear cover bottom. 5. Open the Roll Paper Cover. 6. Remove the three screws (CBS: M4×8) (six screws for Stylus Pro 9600) holding the rear cover top, then remove the rear cover, while pulling it rearward. C A U T IO N To avoid getting hurt with sharp frame edges, be sure to wear gloves when performing the following work: Removing and installing the Rear Cover Inserting your hand through the opening in the Access Cover (see Check Point on the next page) Screws (CPS: M3×12) ×2 Revision A Blank Panel Screws (CPS: M3×6) ×2 Screw (CPS: M3×6) Figure 4-16. Rear Cover Removal 1/2 Screws (CPS: M4×8) ×3 Screw (CPS: M3×6) Disassembly & Assembly Screws (CPS: M4×8) ×3 Figure 4-17. Rear Cover Removal 2/2 Removing the Panel Unit and Housing 166